Tina R16烧录说明
R16 burning instructions
R16烧录说明
1.Installation PhoenixSuit
安装PhoenixSuit
Download the PhoenixSuit_CN.msi file and double-click to run it.
Click next
下载PhoenixSuit_CN.msi 文件,双击运行。
点击下一步
Select the software installation path, and then click Next.
选择软件安装路径,然后点击下一步。
Click Next to install the driver.
点击下一步安装驱动。
2.Burn .Img Into R16
烧录.Img进入R16
Copy the compiled and packaged firmware to the computer
将编译打包好的固件复制到电脑上
The R16 firmware is in the ~/tinaV2.1/out/astar-parrot/ directory
tina_astar-parrot_uart0.img file
R16的固件在~/tinaV2.1/out/astar-parrot/目录下的
tina_astar-parrot_uart0.img 文件
Open the PhoenixSuit software, click a key to flash and click Browse to select the firmware to be burned.
打开PhoenixSuit 软件,点击一键刷机并点击浏览选择要烧写的固件。
Connect the computer and the development board with a USB cable, ground the L14 pin of R16, and then turn on the power supply until the L14 pin of R16 is floating when the following window pops up, and click Yes.
用USB 线将电脑和开发板连接,将R16的L14引脚接地,然后接通电源,直到弹出下面的窗口时将R16的L14引脚悬空,并点击是。
Wait for the programming to complete.
等待烧写完成。
Programming is complete
烧写完成
is complete**
烧写完成
[外链图片转存中…(img-jAuXoIwQ-1598401200731)]