Cisco Packet Tracer配置静态VLAN的步骤

1：VLAN数据库配置模式创建VLAN：                                                                                       Switch#vlan database   进入数据库模 式                                                                                     Switch(vlan)#vlan       2nameT1             //添加VLAN2，并命名为T1，如果不指定VLAN名称，交换机自动使用默认VLAN0002

   Switch(vlan)#exit      //退出，保存             

2： 全局配置模式创建 VLAN：                                                                                                         Switch(config)#vlan 2                                                                                                                   Switch(config-vlan)#name T2

3：将端口加入VLAN：

Switch(config)# interface interface-id                                                                                              //inter f0/1  进入要配置 的端口

Switch(config-if)# switchport mode access                          

//sw mode acc  定义二层端口模式

Switch(config-if)#switchport access vlan vlan-id                           

//sw acc vlan 2  将端口添加到VLAN2中

4：也可同时将多个端口加入VLAN：

Switch(config)# interface range f0/1  –10

                            //inter rang f0/1 -10  选择端口1-10                                                                       Switch(config-if-range)# switchport access vlan vlan-id

                            //sw acc valn 2 将端口1-10添加到vlan2Switch(config-if)# switchport mode access

5：查看：show vlan brief

Switch(config-if)# no switchport access vlan vlan-id                             

//no sw acc vlan 2 将其从vlan2里面删除

Switch(config)# default interface interface-id

                             //还原接口为默认配置状态